This is on a 20 amp circuit. It only ran at the higher amps for less than 30 seconds. Verified the settings for the 4th time and set the amps back to 8.5 and shot this video.
https://youtu.be/sbOd8830D6I
I understand due to my input voltage that I will never see the power it could using 220 but I didn't think it would be this bad. I have trim routers with more balls than this. So if this is as good as it gets I guess ill need to sell this setup, call an electrician to rewire my tapped panel and get a proper 220v vfd/spindle.
I was lead to believe that you can program the input and output amps to control the ceiling of power it will consume.