I have an E3 cnc from Bob's cnc. It was working pretty good for a newbie. Then I started a new project all went well, I

could get it to home and jog even reset home and return to home where I had reset. All of the functions worked until I hit

run then it did nothing just stayed in one spot. I tried some of the other gcodes that had i had ran successfully before

and none of them would run at that time. I just gave up until a few days ago. I tried again and nothing had changed so I

opened the firmware settings and turned off the soft limits ( changed from 1 to 0) when I tried running again everything

seemed to work I just had to be careful with my measurements. One other thing when I get an error I have got to close the

program down and start over. I have checked after an error message if I check the firmware settings it is blanck until I

start the program over.
I sure could use some help if you have any ideas.