[4MInnovations]

Hello, I am new to the world of cnc and I just got a nakamura superturn 2 with a Fanuc 10TE-F controller. I do not have the programming manual and I would like to know how to use my lathe. Would it be possible to have the programming manual or help to build one.

[4MInnovations]

I need help or at least a good start.

[positiverake]

Do you know how to set it up, touching off tooling etc. ? does this control have FAPT?

[sinha_nsit]

Basic programming codes are same on all Fanuc machines. Set-up method would be a little different. For learning programming, grab any programming book to start with.

[4MInnovations]

Do you know how to set it up, touching off tooling etc. ? does this control have FAPT?

Well i do know how too setup a cnc lathe, bot not on tha contrôle, and yes it does have FAPT ..... I was planning to use G cood

[positiverake]

Well then sinha_nsit reply is a good starting point, imo Fapt is great for lathes, it will generate the g code for you.

[4MInnovations]

Well then sinha_nsit reply is a good starting point, imo Fapt is great for lathes, it will generate the g code for you.

I do master the G code, i have rite many program over the Time
But i was using a milltronic cnc lathe that have the original manuel
For the machine. Yes milltronic use standard fanuc g code.

The ting giving me problem is the contrôle , did not find the user manuel.
And i did not figures how to puntch the program in .

Is it posibul on this control to run a program wit the MPG. Like fadal contro do ?

[4MInnovations]

I do master the G code, i have rite many program over the Time
But i was using a milltronic cnc lathe that have the original manuel
For the machine. Yes milltronic use standard fanuc g code.

The ting giving me problem is the contrôle , did not find the user manuel.
And i did not figures how to puntch the program in .

Is it posibul on this control to run a program wit the MPG. Like fadal contro do ?

By the way , it is m'y associé that started this post, he is effectiveley new in cnc Word, but i do have cnc noledeg but not in anglich riting soree if its hard to read tanks for yor compreandtion .