586,796 active members*
2,543 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > G-Code Programing > Locate re-start point in program when stopped mid-cycle.

Thread: Locate re-start point in program when stopped mid-cycle.

Results 1 to 3 of 3
  1. 11-02-2018, 05:06 PM #1
    Robert2018
    Robert2018 is offline
    Join Date
    Nov 2018
    Posts
    2

    Question Locate re-start point in program when stopped mid-cycle.

    Hi all - I'm completely new to using CNC hence the newbie question.

    If using a Heidenhain CNC how would someone locate the correct re-start point in the G-code program when the machine is stopped mid-cycle?

    Thank you.
    Reply With Quote Reply With Quote
  2. 11-02-2018, 07:29 PM #2
    awerby
    awerby is offline Member
    Join Date
    Apr 2004
    Posts
    5742

    Re: Locate re-start point in program when stopped mid-cycle.

    I'm not familiar with Heidenhain, but in general, you note down the position of the tool, according to the DROs, and then look for the instruction in the G-code that sent it there. Start on the next line after that.
    Andrew Werby
    Website
    Reply With Quote Reply With Quote
  3. 11-02-2018, 10:25 PM #3
    Robert2018
    Robert2018 is offline
    Join Date
    Nov 2018
    Posts
    2
    Quote Originally Posted by awerby View Post
    I'm not familiar with Heidenhain, but in general, you note down the position of the tool, according to the DROs, and then look for the instruction in the G-code that sent it there. Start on the next line after that.
    Thank you awerby.

    I should have said in the OP, though yes it is G-code as per your reply.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules