..........
..........

I was able to find a Tree Journeyman 325 Knee Mill with issues on it's Delta20 (Dynapath) controller.
I do have a 10hp. three phase motor that I will be setting up as a rotary phase converter to power this three phase machine.
I purchased this machine for $1000 and it is now in the garage ready for the retrofit.


Here are a few pictures of this machine: Here


This retrofit will be done with the Dynomotion:
Kflop Controller
Kanalog Expansion Board for KFLOP

On the Dynomotion WIKI support page there is:
under the support--> wiring diagram schematic for the Tree 325
which has a two page PDF schematic made by Rick_B.

The person who made this two page Schematic has successfully retrofit his Tree 325 with the existing servos/powersupply and was kind enough to share this information.
I am sure these pages make sense to many or you; however, I have much to learn before I can look at them and say, "great, now I know exactly what to do".

Really going to need help here .....

.....
.....