Hi Tom,
I have a few questions regarding the Screen editor I know you have made a lot of improvements since I last tried it out.
1. Is it possible to have 2 pages in KmotionCNC similar to how Mach3 had tabs for different things? If not is this something that may be available in future updates? It would be nice to have a large separate screen for I/O status for trouble shooting.
2. Also is it possible to have a console screen readout added to the Kmotioncnc screen? A lot of my C programs for tool change and zeroing have console messages that pop up telling me the status of the C code routine.
3. Is it possible to have a status on the Screen that tells me what tool Kmotion thinks is in the spindle memory? I’ve ran into times during my tool change trouble shooting where the tool change doesn’t completely finish the routine and the tool in the spindle no longer matches what is in memory. Then when it resumes it tries to drop off the new tool in the old tools spot which is a potential collision. If I can see what tool it thinks is in the spindle at the time of tool change aborts I can configure my tools properly to resume without further complications. (I'm still going to send you my tool change C code once I get it all worked out, I haven't forgotten)
And for what it’s worth, I’m very glad I dropped Mach3 and focused strictly on using KmotionCNC.
Thanks,
Dan