Hi,
Recently been trying to cut out some intricate designs via importing DXF into Newlydraw.
What I've found is that the internal shape cut out very often hangs on by a mini 'tab', because for some reason, the start and end of the cut didn't end up joining.
Is this a common problem? I have exactly the same issue when cutting vinyl sheet on my CNC router (using one of the Chinese bullet shaped drag knives)
Is there a way to 'overcut' paths?
Cheers
Edit: I forgot to say, the focus and power levels are close to correct at least, because the cut comes out clean and consistent. It has crossed my mind to increase power to see if it fixes, but I would rather not cut the whole piece hotter than I have to to get around this.