Hello Sir
I have same 914 alarm on my Takisawa Tap center OM FANUC
I have lost memory due to low battery, but now I’m getting 914 alarm, if I reset memory
920 watchdog alarm comes up..
Could you share if I have to buy some chips?
Hello Sir
I have same 914 alarm on my Takisawa Tap center OM FANUC
I have lost memory due to low battery, but now I’m getting 914 alarm, if I reset memory
920 watchdog alarm comes up..
Could you share if I have to buy some chips?
Hi I am having the same trouble Alarm 914 ram parity Servo.
Can someone help.
Thanks!
TMM2089P-45 4 ICs in red circle Attachment 459132
you can replace by MB81C79A-45P
Please state your control masterboard # and any photos of the screen and control.
this is my board number
this is a pic of screen.
dear sir i am have problem with is alarm
Most likely it involves one or more of the chips in the two rows in top middle (below MADE IN JAPAN FANUC ). If they are socketed, it/s easy to replace.
this one
Yes, and the 28 pin ones to the left.