Hello guys
I had my tb6560 4 axis board for more than 3.5 years now and it was working flawlessly
never gets hot nor the motors, never had any problems with the board, not even missed steps
I am not a hard worker on it but I use it often
yesterday was working fine, today just powered up and it did not operate and I started to smell the smoke
I know and heard about the so many problems of this board but this board worked flawlessly all the past years
I did not change anything since last time it was working
I operated and it worked, jogged the machine a little bit then I clicked the soft stop from mach3 (` key)
then it seems that I accidentally clicked it again so i clicked it again to put the machine on sleep as it is nosy and I was fixing a job on the table
then when I tried to operate again it did not operate and I started to smell the smoke, turned it off and took those photos
any explanation for this?
can it be fixed?
I cant spot any damage other than those 3 spots
a blown small component (dont know its name) model E388
and these cut off wires
any help would be greatly appreciated
Attachment 377098
Attachment 377100
Attachment 377102
Attachment 377104