Hello,
I'm converting my lathe from Mach3 to the new Centroid Acorn controller Acorn CNC controller, Step and Direction 4 axis CNC Control board with ethernet communication. and was looking for a PP for Dolphin Partmaster lathe. Thanks!
Hello,
I'm converting my lathe from Mach3 to the new Centroid Acorn controller Acorn CNC controller, Step and Direction 4 axis CNC Control board with ethernet communication. and was looking for a PP for Dolphin Partmaster lathe. Thanks!
Milton in Tennessee ya'll!
Working on it Milton! lol
Hello Milton,
I have just checked on the Centroid website and found a user manual that lists the G and M codes.
They look identical to MACH / Fanuc
I would use the MACH3 post as a good starting point, you may find it works without alteration.
The only thing that I did notice is that the Centroid doesn't support G81 Drilling cycle so you will need to use G83 - Deep/Peck drill.
If you have a G code program that you know works, send it to me and I can make any changes required to the MACH post to make one for the Centroid.
ATB
Andre
That's fantastic news Andre; thanks so much. You are great as always! :cheers:
Milton in Tennessee ya'll!
DickeyBird,
I was doing the same thing looking for a post processor for Centroid and as andre pointed out the drill cycle is handled different in Centroid than Fanuc. However I did select peck drilling and it misses the first hole, see my post on Acorn site. Anyway I am sure someone has figured this out on the zone.
Russ