I need some help! I just purchased the Tormach 1100 Part Maker Package with full enclosure, ATC, RapidTurn, Tilting 4th axis,..........
So far here have been my issues....
1. The controller was bad (would not start up, Tormach sent a new one)
2. After assembling the stand, mill, enclosure, putting on the ATC (not dialed in as of yet) I lost all of the lights and power to my drivers.
3. Tormach sent pictures of the correct wiring inside the E-Stop relocation switch (lights and power are now back on) but, when the controller fires up and I reset the E-Stop and hit the start button, I can see on the controller that the X, and Y axis are active and noted to the left on the screen and lit up on the right with the green bubbles, but the Z axis is not showing on either side and I cannot hit the reset button in PathPilot without getting an error code "Command cannot be executed unless machine is powered on and the control software is out of RESET". The machine is on all driver's are lit the added circuit board led's (red and yellow) the red is lit but the yellow is off. And I cannot move the X,Y,Z with the keyboard or shuttle.
Any thoughts?
Also I do not have a Enclosure door switch and the box is not checked in PathPilot.