[Tancuda]

Hi everybody,

I'm testing a macro with the simulator in Manual guide i,
and been searching in the books without help.

Actually, it will skip all my variable in the program (#500= x.xxx etc..) and the skip block sign (/),
so nothing will work.

Is there a parameter for that ?

Did that a few years ago on a Oi control and it was ok.

Anybody have the same problem ??

Thanks a lot

[Tancuda]

Updating my previous post...........

Here a test I made:

O0001;
#500=2.0
G0 X1.0 Y#500
M30

It went to X1.0 Y2.0, but the #500 variable still at 0 !!
So could the MGi transfert variable elsewhere ??

Thanks

[norbert.barnard]

Hi,
is your machine 1 one-path system ?

MGi will not interfere.

regards

[Tancuda]

Sorry, not sure what you mean by "one path system"

I can program in MGi and out of MGi too, but the simulator is only on MGi

Thank Norbert