[baran3]

I was wondering if anyone else gets a lot of crashes using MCX2 especially when transforming and then selecting undo. I have had a few times where i have lost all my entities and toolpaths and was wondering if there are certain things that I am doing to cause this. It seems at times to me that it is "crash prone". I have been using it for about 2 months and just wanted to know if this is common or just some things I do at times to bring the problem about.

[Matt Berube]

I have had occasional crashes but overall X2 is MUCH more stable for me than any other version since I started on MCAM 8.

I haven't seen anything I'd blame on UNDO or XFORM.

My best advice would be to save often and to spend a few minutes setting up "backup files". You'll never know it's there until your file gets hosed but then you'll be glad you set it up.