After almost destroying my Gecko G540 due to an electrical issue of my own creation. I've figured out how to wire in a new power plug input. But the original switch I had at the front of my controller has me stumped. It has 4 pins and an LED. Originally it would stay lit even after I had turned the power off. Has anyone any idea how I should wire this to alleviate this issue using all 4 of the Pins?
Thread: Adding New DPDT Switch
Results 1 to 2 of 2
-
12-15-2017, 03:07 AM #1
Registered
- Join Date
- Sep 2008
- Posts
- 148
Adding New DPDT Switch
-
12-15-2017, 11:51 AM #2
Registered
- Join Date
- Jul 2016
- Posts
- 660
Re: Adding New DPDT Switch
Just pull-out the two upper wires and transfer it to the bottom connectors, same as the two bottom wires, transfer it to the top
the same switch position.
Reply With QuoteSimilar Threads
-
Z axis has a brake - adding a limit switch to activate the brake
By KipKirol in forum CNC Machine Related ElectronicsReplies: 5Last Post: 11-16-2017, 11:31 PM -
Adding a rotary table to an already 4 axis machine - can I switch between them?
By BigDamo in forum FanucReplies: 26Last Post: 05-24-2014, 03:41 PM -
Adding a low air pressure switch to TL2
By JohnJW in forum Haas LathesReplies: 2Last Post: 06-01-2012, 09:32 PM -
Adding E-Stop Switch
By JohnLucas in forum Taig Mills / LathesReplies: 10Last Post: 09-21-2011, 10:19 AM -
adding rapid override switch to 3T?
By etpm in forum FanucReplies: 7Last Post: 03-25-2011, 10:16 PM
Tags for this Thread
Posting Permissions
