Goodmorning everyone
I have a problem with a Geckodrive G212, it loses steps.
I tried to move the drive on another axis, the problem has moved on this axis.
I bought a new drive, I set the pinout in the same way as the old one, but the axis does not move. If I put the old one back, even if I lose a few steps, the axis moves.
I enclose the photos, the only differences I see are the version (old / 14-new / 17) and the 7th foot (old NC / new Reset).
The breakout board I use is a PMDX-131.
Do you have any idea why this happens?
Thanks to everyone and happy holidays.

Gian Carlo
Attachment 382442
Attachment 382444
Attachment 382446