Hi there,
I am considering to switch from a grbl based system with integrated motor drivers to a Arduino Due with Tiny G2core firmware, because I can then use external drivers (read: closed loop).

Now in researching github and the forums, it seems, that there is ver, very little development going on and there is not a synthetos own board available that lets you use external drivers which would make it easier to get support.

Has anyone been using g2core and can report on functionality or stability?

I am also looking around, what may be the best way to send gcode to such a setup (chilipeppr is one option I know) - a simple minimal GUI with a few buttons like performing jogging, homing and loading/sending a gcode file would be sufficient. Since the Due/the processor has no eepro storage, how does everybody store the machine setting? Do you always re-compile the firmware and flash it, once you have the need to change a setting?

If there is anyone around here, that can provide some tipps!

Thank you,

Michael.