[CS900]

Hi there, I'm hoping you guys could help me out real quick. I have a project that I'm working on right now and it looks like the 1100 Y or Z axis way covers might be a good solution for chip guarding. Looking on the tormach website they certainly are economical enough, but don't give any dimensions. So I'm hoping someone here could grab a few for me. For Y and Z covers I'm looking for:

- Width. I found documentation saying 320mm, but I'm not sure if that's the overall or the opening for the dovetails. I guess it would be super cool to know the inside width when fully compressed.
- compressed length
- extended length
- height. again, inside height would be super cool.

Thanks guys!

[Djstorm100]

Are you just lookin for a flap to cover the existing way covers? You can get a roll of it at Mcmaster Carr. Just get a roll and cut it.

[CS900]

No, I'm looking for the folded covers that cover the top and sides of the dovetials.

[Djstorm100]

Just buy them from Tormach. Or call them, they will help you out