Hello,

I'm having problems with the spindle in my Machine Center Mazak VQC 15/40 M32 .

After M19, my spindle orients properly but it jerks suddenly.
Too bad when this happens on a tool change.

Also if i rotate the Clamped spindle by hand it moves 2 to 3 degrees and again tries to restore its original position. Sometimes with an horrible noice.

I think need to increase the clamping force.

1. Is it possible to change through Parameter Setting ?
2. What is the recommeded force ?
3. What is maximum force & need to know if any consequences are there if the force exceeds maximum limit ?


Enviado desde mi GT-I9500 mediante Tapatalk