Hi all

I have only been machining for about a month now and have been using Artcam in combination with Fusion360. I can tell you that my luck is the reason that Autodesk has decided to discontinue Artcam, and now I really need some advice.
The past month I have been using Artcam exclusively for engraving, and when I heard about it being discontinued, I immediately looked for other software solutions.
I managed to get Type3 to send me a dongle with 1 month free trail of Type Edit. Unfortunately It just felt extremely over complicated and cluttered in comparison to Artcam - Achieving the simplest of tasks took about 5 extra steps.
I really would appreciate some advice on which software I should look at as a replacement - I have looked at TypeEdit and Aspire.

Please remember, I'm very new to this.