Anyone have any success simulating with this latest version? Mine will draw paths, but that is about it. Any attempt to draw the part results in a jumbled mess. After numerous attempts to get it to work, I downgraded to the Oct 31, 2017 version, which I was running before, and the simulator won't run on that version at all now. The system just hangs and eventually becomes non-responsive. I tried earlier versions with the same result. I tried uninstalling MadCAM then reinstalling. Still crashes. So I uninstalled Rhino and installed everything again. I still can't get the simulator to run with the MadCAM version it was sort of working with prior to the update. I had some simulation before, now I have none. Ughhh!!

Ken