Is there a way to store a position (say the back Left edge of my vise jaw) in the machine position and recall it without having to indicate it in every time? So that after I power on the machine, I can go to machine coordinate (X,Y) then it will be over the corner of the vise, and all I have to do is touch off with the first tool for Z.
I understand there would probably be some deviation due to the homing switches and backlash, but if it was within a few thousands, I could live with it if I was just making a quick fixture, where the features just needed to be relative to each other and not the edge of the work piece.
Thank you!
(I'm using Path Pilot v2.0)