I've been told the Doosan Machines with a fanuc controller has a thread repair cycle, I have a new Lynx and I would like to try it but I haven't found any documentation on how to do it so I'm hear asking if any one knows how. Thanks
I've been told the Doosan Machines with a fanuc controller has a thread repair cycle, I have a new Lynx and I would like to try it but I haven't found any documentation on how to do it so I'm hear asking if any one knows how. Thanks
Isnt that under Manual Guide ?
Under the EZ guide, I just have never done it or know anyone that has.
It exists.
Email me for the documentation.
[email protected]