Hello All,
I have a problem with KMotion on my lathe I don't understand. I have a turning shape generated in fusion 360. I can run it in Mach 3 all through to the end. The code is generated as Fanuc turn. When I try to run the same code with KMotion I have to delete the G50 and G54 lines. It then runs until it gets to the first G3 arc command. It stops and gives the message -Radius to end differs from radius to start. I have seen the same problem anytime I try to do manual code it will not run an ellipse. It seem it will only accept a true arc.Is there a setting in K motion I need to change? Thanks for any help.
Scott