HELP PLEASE: I own the above machine which I am converting to a CNC. I have a problem with the control of the spindle speed.
On page 26, Figure 4.2, a 4-pin connector underneath the control panel is indicated as the "Start-stop connection CNC-Controller". I have opened the box and saw that there are two red wires connected to two of the pins of the connector.on the inside. My question is whether this is the connection that one must use to connect to the break-out board to control the spindle speed or is this just for the start and stop of the spindle?
I would really appreciate if somebody that have done such a CNC conversion on either a BF20 or Grissly 0704 or any of the other similar machines, can help me out.
Thanks
Ockert