Hey guys,
Building a device which may become a Router in future, but just a modular setup table for now, and wondering about some general 8020 tips. The tabletop perimeter and some intermediate beams will be 1530, 3" face vertical.
What tips/hardware do you suggest for getting good squareness out of 90deg joints? (3" face inside)
What can I expect if I just do a combo of inside connectors like #4304 (or gusseted like #4438) plus right angle flat plate like #4481 on bottom?
Permanent bottom plates necessary? Or just clamp something flat while bolting inside corners?
Any advantage to something like ground CI angle plates and some similarly flat material for bottom?
I have a Taig CNC mill and a horizontal bandsaw, fwiw.