As was announced earlier, our new MPG101B Pendant takes advantage of the open development aspect of MACH3 and offers a configurable 28 function hand held controller/pendant that has a unique dual axis proportional jog stick. It interfaces with MACH via 6 inputs of a high speed parallel port (port 2). The initial announcement stated the MPG101B was being released for our MP1000 line of Interface products (THC, Router[basic] and Spindle Speed). With the addition of our new Port2B card any PC with MACH3 and a 2nd parallel port can be used with the MPG101B.
For a limited time we will include a Port2B interface card with any New MPG101B ordered at the standard price of $169.95 for 1 cent!.
NOTE: Port2B needs a source of +5 volts at 150ma from a PC referenced source for MPG101B operation. Some Port 1 breakout cards have an Auxillary +5 supply that will drive the card or you can use the internal +5 of the PC.
Also available is a "voltage-tap" interface ($7.95 USD) that can be attached to the back of any PC with an empty slot and provides the +5 to run the Port2 card for pendant operation. It plugs into any spare power connector from the internal power supply and we furnish a cable for the PC power to Port2 connectors.
Port 2B card also has additonal opto isolated inputs and buffered outputs so all of the port 2 pins can be used, but it needs a plug-in satellite card (breakout) to access the extra inputs/outputs.
A separate +5 (separate ground) is needed only if the added opto isolated inputs and outputs are used.
Info at http://www.CandCNC.com/MPG101.htm
Plug-in and MPG101B Manual at http://www.CandCNC.com/PDF/MPG101Manual.pdf
Website at http://www.CandCNC.com