[Etaniyani]

hey guys, i have been using a tree 2uvr for a couple years now, and i just purchased a webb tw-96 cnc controlled. two error codes on the dynapath display that i am trying to figure out.

back up battery low: located the battery, will replace
touch multikey is not present or invalid: any thoughts?

the machine is in fairly good condition, but cant be operated because of the errors...the owner also said the parameters have to be re-programmed...

any thoughts to get started on fixing the couple problems? thanks in advance.

[Etaniyani]

just as an fyi incase anyone else was having these problems...

the touch multi-key is located on the transducer board, looks like a battery but its actually the "touch multikey" programmed for this specific board. ordered one up.

backup batter is on the flash memory card, soldered in place. ordered the parts and should be ready to go after that.

[JOSEBUST]

just as an fyi incase anyone else was having these problems...

the touch multi-key is located on the transducer board, looks like a battery but its actually the "touch multikey" programmed for this specific board. ordered one up.

backup batter is on the flash memory card, soldered in place. ordered the parts and should be ready to go after that.

Hello.
7 years later, I have the same problem with the error: "TOUCH MULTIKEYIS NOT PRESENT OR INVALID"
don't located this TOUCH MULTIKEY can you help me, please?

[JOSEBUST]

Hello.
I have a problem with the error: "TOUCH MULTIKEY IS NOT PRESENT OR INVALID"
Where can I locate this TOUCH MULTIKEY can you help me, please?
I'm from México.