[0JFK0]

Hi all,

I have receive my Chinese CNC some days ago.
I'd like to add end limit switch on each axis.

No problem for the switch placement and fixing, but I need you help and ideas on where to wire it on the main board of the controller.

I guess it's on the Phoenix connector (see attached photos)
I have slots available named :
REV / MI1 / MI2 / MI3 / MI4 / Mo1 / +12V.

Did someone can guide me for the switch wiring ?
And if possible, on Mach3 settings (or a right link).

I'll will use a Z prob too, I have buy a cheap molule on Ebay, if any one have information on how to wire it and set it in Mach3, thank you.

Thank you in advance.
Regards.

[0JFK0]

No one ?

[0JFK0]

Solved

[Bri957a]

Solved

Can you send some info about what does those ports mean? Mi1 mi2 mi3 mi4 mo1 +12v

What i want to do is hook up a zero out plate for the Z axis

I have the same unit so i was wondering what those ports mean?

[0JFK0]

Can you send some info about what does those ports mean? Mi1 mi2 mi3 mi4 mo1 +12v

What i want to do is hook up a zero out plate for the Z axis

I have the same unit so i was wondering what those ports mean?

Hi,
If you have the same as me.
All information you need are there:
https://drive.google.com/file/d/12EH4MFnGzktkZNnk-psuNUzFEEplddBj/view?usp=drivesdk
Regards

[Bri957a]

Ok i see the page, but the Mi1 Mi2 Mi3 Mi4 Mo1 +12v, is not listed in these prints... i would like a Z Zero plate, or to make one for my
Cnc machine.

[Bri957a]

Ok i see the page, but the Mi1 Mi2 Mi3 Mi4 Mo1 +12v, is not listed in these prints... i would like a Z Zero plate, or to make one for my
Cnc machine.

My board looks like the one in the pictures attached in this thread