I have a setup consisting of:
-- Taig mill;
-- 166 oz-in stepper motors;
-- Gecko G540;
-- 48V motor power;
-- Ethernet SmoothStepper;
-- Mach3; and
-- Windows XP/SP3.
I have been having some strange, infrequent but frustrating errors within Mach3 that I just haven't been able to figure out, and I'm considering migrating to Mach4 instead, to see if that may just work in my case.
Has anyone made this same migration from Mach3 to Mach4 with a similar setup? I would deeply appreciate any impressions or recommendations with this process, and/or a working and debugged profile if you've gone one.
Thanks for any advice;
--dave