Hi Guys.. Hope that someone has experienced this same issue.
PMX 45 Price Avhc10...
Had this up and running wonderfully for ages cutting everything from 1.2mm through to 12mm steel on the table with not an issue.
Suddenly i find that the voltage displayed on the AVHC generally starts off accurate and the unit is working say at 127V then all of a sudden mid cut the
displayed voltage will jump to 190v plus and the THC stops working.... If I watch the voltage reading closely it seams to flick back to the correct voltage momentarily
during the cut but on the whole does not work.....
Changed consumables. checked wiring , checked earth... Dont understand it
Any ideas Guys????
Thanks in advance