587,427 active members*
3,092 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > BobCad-Cam > BobCad Post Processors > Need Mach3 post for 4th axis

Thread: Need Mach3 post for 4th axis

Results 1 to 10 of 10

Hybrid View

  1. 06-27-2018, 09:20 AM #1
    The Engine Guy
    The Engine Guy is offline Registered
    Join Date
    Jun 2008
    Posts
    1838

    Re: Need Mach3 post for 4th axis

    Eric

    P.S. I assume that you have set the axis to Y as shown in the image below ??


    Regards
    Rob
    Attached Thumbnails Attached Thumbnails 4 axis Y setting.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. alphacam 4-AXIS post processor for mach3
    By Aburmaiz in forum Alphacam
    Replies: 2
    Last Post: 03-10-2022, 08:20 PM
  2. I need a post processor for mach3 with 5 axis, any software!!
    By caioassaf in forum EdgeCam
    Replies: 2
    Last Post: 07-06-2017, 02:15 PM
  3. I need a post processor for mach3 with 5 axis, any software!!
    By caioassaf in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 02-23-2017, 12:22 AM
  4. MACH3 5 axis post for Solidcam?
    By mjb777 in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 2
    Last Post: 11-18-2013, 10:16 PM
  5. post Edgecam to Mach3 5-axis
    By DL2008 in forum EdgeCam
    Replies: 1
    Last Post: 11-14-2010, 03:52 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules