Switched to NEMA 23 steppers and TB6600 drivers, motors still only getting 5V, can't figure out what I'm doing wrong, attaching photos of setup, can anyone tell how I need to
wire this turkey?https://www.cnczone.com/forums/attac...d=397114&stc=1
Switched to NEMA 23 steppers and TB6600 drivers, motors still only getting 5V, can't figure out what I'm doing wrong, attaching photos of setup, can anyone tell how I need to
wire this turkey?https://www.cnczone.com/forums/attac...d=397114&stc=1
Thanks for your reply, have 30V power supply, have 5V and 30V connected properly, what I don't understand is what wires go to enable, step, and pulse.
If you share some pictures here to show
We can help you to check
https://www.automationtechnologiesinc.com/