Hi all,

Recently I got following items:
- Breakout board
- Driver DC 9-40 VDC
- Motor 4phase - 3.6V - 2.0A (/phase) - resistance: 1.8 (ohm/phase) - inductance 2.5 (ohm/phase)
- power supply: 12VCD 30A
Connected tp PC by paralle cable with USB as 5vdc supply for Breakout Board.

When I run stepconf to configure this setup I hear and measure that signal is passing BB. I can measure that it at signal side of a driver (obviously) but I do not measure any output on highvoltage side of the driver. jumpers on that drivers are set to microstepping 1:1 and amps to 2 (2.2 peak current).

Anyone who knows how to help me with this?

regards