Just finished my first cad drawing ever but can't get anything but a blank page to print any help out there thanks Kenneth
Just finished my first cad drawing ever but can't get anything but a blank page to print any help out there thanks Kenneth
thanks Kenneth
www.lambertsrc.com
do you have the latest v19 upgrade? if not it is supposed to "fix" the printing problem...
http://www.bobcadsupport.com/
i downloaded fix # 3
thanks Kenneth
www.lambertsrc.com
kenlambert
It is true the problem has been fixed, try going to your bobcad shortcut under the start_programs menu and run a live update, this will fix the printing issue as well as a few others.
Let us all know how you went.
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
it says no updates were found
thanks Kenneth
www.lambertsrc.com
Ok kenlambert,
I will look into it for you, give me 24hrs
Cheers
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
ok thanks
thanks Kenneth
www.lambertsrc.com
Kookaburra
it worked that time around thanks for the help Kenneth
thanks Kenneth
www.lambertsrc.com
great to here kenlambert.
The only thing I could think of was if you have an entity selected it will only print that entity and if the particular entity is tiny it may pass off as a piece of dust on your page, it is always a good idea to get into the habbit of deselecting all of your geometry before printing.
Enjoy
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)