Hey guys,
came in today and started my fanuc lathe and was greeted with a SV 019 Unfit pulse of pulse coder alarm on all 3 axis (X,Z,C). I have never seen this before, hell I dont even know what a pulse coder is. Any help would be appreciated.
Thread: Unfit Pulse Of Pulse Coder Alarm
Results 1 to 3 of 3
-
04-23-2007, 03:04 PM #1
Registered
- Join Date
- Mar 2007
- Posts
- 215
Unfit Pulse Of Pulse Coder Alarm
-
04-23-2007, 03:36 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24221
You dont mention what control? The encoders are on the end of the motors, it is highly unlikly that you have three failures, so it is something that is common to all.
With a 10 for example, the fault is a defective PCB (board).
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
04-23-2007, 03:55 PM #3
Registered
- Join Date
- Mar 2007
- Posts
- 215
Yeah, it is a 10. However the alarms were able to be reset. I was just making sure there isn't something I should be doing or if maybe it was a fluke.
Reply With Quote
Similar Threads
-
pulse jet
By kurt98 in forum Hobby DiscussionReplies: 1Last Post: 04-10-2007, 02:17 AM -
pulse jet or ram jet
By jetta in forum Hobby DiscussionReplies: 3Last Post: 02-05-2007, 12:57 AM -
Fanuc Pulse Coder
By Derek.C in forum FanucReplies: 2Last Post: 01-04-2007, 03:24 AM -
Right pulse for stepper
By cncbox in forum Stepper Motors / DrivesReplies: 4Last Post: 08-16-2005, 06:18 AM -
No Pulse?
By jubee in forum Computers / Desktops / NetworkingReplies: 10Last Post: 07-08-2004, 10:11 AM
Posting Permissions
