Hi,
I am just retrofitting a lathe and am using a Novusun EC500 controller.
https://www.nvcnc.net/ec500.html
The output for pwm and also digital out 1 and 2 for cw and ccw won't have any signal.
I configured it following the manual, but still without success.
I also tried different setups different pins. No success.
GNDS and VSO for the 0..10V input at the Vacon NXS drive
com- and OT1 CW OT2 CCW
Ports and pins
Motor outputs
Spindle enabled / StepPin 1 / DirPin 0 / Step LowActive / Step Port 1 Dir Port 0
Spindle Setup
CW Output 1 / CCW Out 2 / Use spindle outputs / PWM Control / Base 5 / Min 0 /
Output Signals
Out 1 enabled / Port 2 / Pin 1 / Active Low
Out 2 enabled / Port 2 / Pin 2 / Active Low
I can not measure any output at the connectors.
Thanks for your help...