[Dsny]

I have an 'ambigious tool pocket' error that will not reset. Dual arm type changer.
SETTO,# does not work for some reason.
any ideas?

[Dsny]

After another power down then turret rotation, apears OK. No idea what caused the fault in the first place tho.
Thanks

[Dsny]

Back again.
It would appear that I am having an intermittent problem with the turret rotation. Going to check the proximity switch now.

[cncbimbo]

type DI at enter next command and type DD you will goto the DATC diagnostics page . bets are that you are stuck slightly between buckets . use this menu to correct the problem .
if you need help just call the service department at 818 727 2100

[cncbimbo]

Back again.
It would appear that I am having an intermittent problem with the turret rotation. Going to check the proximity switch now.

--- you should be able to tell on the diagostics page if the switch is bad . at DI DD look at the bottom of the menu and you will see if it is open or closed on the switch ...

[Dsny]

The pin that attaches the brake to the shaft had busted.