Hello,

I'm having some issue with my new ShopSabre producing inaccurate cuts. It seems everytime I make an interior cut, whether it is a 2D Contour or a 2D Pocket, climb or conventional, every cut is consistent off by about 1/32".

All of my test cuts have been using the same drawing. Any cut with the tool path on the exterior of the line is perfect, anything on the interior are coming up short. I've gone over my settings multiple times and can't find anything that would offset the tool path and my bit diameter is accurate to the physical bit.

Does anyone have any ideas or suggestions to help me troubleshoot this?

Thanks,
Tim

Fusion file: https://a360.co/2NPIAap
Machines is a ShopSabre RC8
Using ShopSabre with WinCNC control post processor - https://cam.autodesk.com/hsmposts