Hi Guys

I need help with this new import. I've been back and forth with the Chinese supplier regarding this issue.

Let me start off with what we've discovered.

I homed the machine and start the spindle in that position with no problem.
If I move from that 0 position to anywhere on the table, the spindle start and then stops immediately. Mach3 shows "Limits Re-engaged"
The spindle triggers my home M1 and M3, and those 2 light up on the diagnostic page. M1 and M3 is my x and z axis
Disconnecting the X-se and Z-se wires on the control card fixes the issue and I'm able to run a cycle.

My knowledge is very limited, but can send videos and pictures if anybody will be able to assist.

Much appreciated

JP Visser