Does the location of the fault correspond to a point of flexure?
Will this problem re-occur because the cable bends too much in one place?
Results 1 to 7 of 7
Threaded View
-
09-26-2018, 03:04 AM #6
Registered
- Join Date
- Dec 2005
- Posts
- 436
Re: Possible failure - KL34H295-43-8A NEMA 34 stepper
Reply With QuoteSimilar Threads
-
Stepper motor upgrade NEMA 34 or NEMA 42?
By rogerfries in forum Bridgeport / Hardinge MillsReplies: 6Last Post: 07-28-2015, 04:59 AM -
Nema 17 Stepper motor on Nema 23 driver
By Thomas T in forum Laser Engraving / Cutting Machine General TopicsReplies: 6Last Post: 10-21-2014, 08:59 AM -
Wiring a Nem34 (KL34H295-43-8B) to a KL-5056D
By ddragon in forum Benchtop MachinesReplies: 3Last Post: 12-07-2012, 09:52 PM -
Motor Linearity on PK299-F4.5 (from OM) and KL34H295-43-8B (from Kelling) ??
By chicof in forum Stepper Motors / DrivesReplies: 1Last Post: 07-03-2009, 09:26 AM
Tags for this Thread
Posting Permissions
