[RustyR]

My Amada 357 went down so I told my operator to get moving on the 344. It is not working either. Bring the machine/control up, all is good. Zero X,Y,T. Now this is where the problem starts. The turret spins to T201 like it is supposed to and the pin engages but the "Turret origin" light doesn't light up. Send a program over and the machine will not run it. Light may be burned out but I suspect it has something to do wit it. No other errors or alarms.

Update:
I have checked the lights on x&y origin to get a voltage. I have no voltage to Turret Origin light.

[AMADAJOE]

My Amada 357 went down so I told my operator to get moving on the 344. It is not working either. Bring the machine/control up, all is good. Zero X,Y,T. Now this is where the problem starts. The turret spins to T201 like it is supposed to and the pin engages but the "Turret origin" light doesn't light up. Send a program over and the machine will not run it. Light may be burned out but I suspect it has something to do wit it. No other errors or alarms.

Update:
I have checked the lights on x&y origin to get a voltage. I have no voltage to Turret Origin light.

Check your striker signals. You need striker center signal in order to get T origin