Okuma MX55VB OSP 7000M
So I was using a touch sensor w/light to set my work offsets and now got a Haimer 3D sensor.
I use a micrometer style pre-setter to get tool length offsets using the tip of the touch sensor as 0 reference. So any tool longer than my touch sensor had a + offset and shorter tools a - offset.
Now my Haimer is longer than the touch sensor I was using and I wondered if I can enter in MDI to subtract say .927 from all the tool length offsets (VTOFH 1-99) instead of re-measuring each tool offset?
Hope that all makes sense!!
Thank You! Carl