Hallo. Machine cannot work in "teach in" mode when she did not cross the reference points! When you start the hydraulics, you must be able to move all the axes manually, and when you hold down the spindle manual rotation knob, it rotates very slowly! As I understand you, all these things work properly. This si vary good.
This error I35 may have several reasons. The machine have 2 keys. One is on the dashboard and the other is on the right side (behind the console) of the machine. Check the positions of both keys. The key on my console is at position 0 to get the machine through reference points.
The other reason is - the key of the door. I disassembled the contactor (top right above the machine) and tied its two cables short to insulate the door. Machine cooling pumps must also be switched on to prevent this error.
I have the same machine and i may tell you all about it, because I had many problems when I bought it...
I am from Bulgaria, and where are you from?
My e-mail is:
[email protected]
You may sned me letter there and I will help you about all.
Good luck!