Hi. I'm doing a 10 cavity die. I programmed 1 instance of the cavity. It has stops to check things and messages to the machinist as to what to check and what interim readings should be, etc. My stop points are, of course, a Point unit and messages are Manual Entries.
Problem, is when I "transform" it, I'd like to get all the roughing then all the finishing with all the stops and messages in their proper place, but I get Rough, Rough, Rough, point, point, point, message, message, message, Finish, Finish, Finish.
So it is grouping all the roughing then all the finishing, thus doing all the roughing then all the finishing which is right, but its also grouping my messages and stop points together too.
Your help is appreciated.