[Jdubya]

Looks like i can swap out the 1605's for 2005's if my long axis is too slow for a few hundred bucks if needed to gain more RPM's. Are 2005's big enough for that 60" length @ Skrubol for higher rpm's?

[mactec54]

Looks like i can swap out the 1605's for 2005's if my long axis is too slow for a few hundred bucks if needed to gain more RPM's. Are 2005's big enough for that 60" length @ Skrubol for higher rpm's?

Your screw pitch is where you can gain speed 2005 is 5mm pitch this 5mm pitch is normally used for the z axes if you are going to change them get 10mm pitch screws 2010 ballscrews this will double your machine speed with the same RPM

[Jdubya]

Your screw pitch is where you can gain speed 2005 is 5mm pitch this 5mm pitch is normally used for the z axes if you are going to change them get 10mm pitch screws 2010 ballscrews this will double your machine speed with the same RPM

Thanks, i did replace the long axis 1605 screws with 2010 screws after all.