[MaxWeber]

Machine: 2008 Sharp SV-2412
Control: Fanuc Oi Mate-MC

Alarms: 1400 SPINDLE ALARM
607 X AXIS:CNV. SINGLE PHASE FAILURE
613 X AXIS:CNV. SINGLE PHASE FAILURE
607 Y AXIS:CNV. SINGLE PHASE FAILURE
613 Y AXIS:CNV. SINGLE PHASE FAILURE
607 Z AXIS:CNV. SINGLE PHASE FAILURE
613 Z AXIS:CNV. SINGLE PHASE FAILURE
9004 SPN 1 :INPUT FUSE/POWER FAULT

I boot up normally, get the 607 and 613 codes, then after maybe 20 seconds a breaker trips and I get the 9004 code. The servo drive has a normal status until the 9004 code trips, then the LED on the servo drive gives ALARM 04.

Any thoughts on how to diagnose this? I was making chips last night, nothing out of the ordinary. I power up this morning and this is what I get.
Thanks for any advice,
Max

[zavateandu]

you should check your power supply unit,should have a fuse to replace.

[phucrobusl]

send us drive(bisvsp) only to my company CNC TECH SERVICES (RAJPURA) INDIA we will repair this drive on same its hardware problem so if in case its not hardwae issue i will definately help you here but its hardware issue you need to send us company we will repair this on same day.