586,077 active members*
3,845 visitors online*
Register for free
Login

Thread: Fanuc 18i Turret Index limitation? (need help)

Results 1 to 2 of 2
  1. 05-03-2007, 11:08 PM #1
    mcash3000
    mcash3000 is offline Registered
    Join Date
    Feb 2006
    Posts
    22

    Fanuc 18i Turret Index limitation? (need help)

    I am running a Muratec MS100 and I have a problem with a plain head that sticks out too far. As the turret is indexed it will run into the ceiling of the machine,,major problem.



    Does anyone know the procedure to limit the position the turret can index to on a Fanuc 18i controller?
    Reply With Quote Reply With Quote
  2. 05-04-2007, 02:14 AM #2
    Mr.Jaeger
    Mr.Jaeger is offline Registered
    Join Date
    May 2007
    Posts
    3
    I think its done by the logic in the turret.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fanuc 18i - KIA SKT250MS - Turret ?
    By Joey in forum Fanuc
    Replies: 20
    Last Post: 02-27-2007, 05:23 PM
  2. Turret Index Only Once In Auto
    By rajesh_1355 in forum Fanuc
    Replies: 1
    Last Post: 01-29-2007, 12:48 AM
  3. HELP! need FANUC motor for my turret press
    By recycleroy in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 09-28-2006, 08:19 PM
  4. Help with FANUC O-MD and index signal (M21)
    By Sump Cleaner in forum Fanuc
    Replies: 3
    Last Post: 12-27-2005, 08:54 PM
  5. Tool Turret Index Failure
    By hatchmar in forum DNC Problems and Solutions
    Replies: 6
    Last Post: 06-10-2005, 12:36 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules