[Biggermens]

Hi Everyone

I just got a copy of Mach 4 V2 and running a ESS
I setup my motor and when i try to Zero I get a error message
Axis 0 Commanded While Disable

I did not have this error when i was running the demo
Anyone have any ideas ??

Thanks in advance

[ger21]

My guess is that you have a motor disabled, or not enabled, and your g-code is trying to move that motor.

Go through your configuration very carefully..

[Biggermens]

Hi Gerry

I only get that when i click on Go To Work Zero
I double check everything, it jogs and go home perfect, i never tried to run code with it yet
I even tried to make a new profile, and setup only one axis and i got the same thing

Thanks

[Biggermens]

I googles it and it seams like other people had this problem also
Lots of the search results that go to the mach support page and you click on any of there links and it bring you to the main page
Also there search feature don't work
Seams like there is something wrong there

https://www.machsupport.com/forum/in...?topic=35787.0

Thanks

[joeavaerage]

Hi,
I replied to your post on the Mach4 board on the 22.11.

Did it not help?

Craig

[Biggermens]

Hi Craig

Yes i did help Thanks

You were right, my problem was i have motor 3 enable
My X axis uses motor 0 and slave motor 3, so i though i had to enable motor 3
when i took the check out everything was ok,
Seams i still get the error from time to time but everything is working well
probably something in the button scripts

Thanks