hi, lots of problems I think. ok so today I installed mach3 on a 32bit PC. connected the CNC4YOU HG08 breakout board to the pc vie the printer cable. wired up the stepper driver as per the wiring diagram shown within CNC4YOU web site. wired up the stepper motor from the same site. connected the power unit. set the ports and pins etc as per the web site. this is what I am getting. On the HG08 board I have two red LED lights showing. ( I have know idea if this is good or bad as there is nothing in the manual about the colour of the LED,s). I have a green LED solid on the stepper driver and below it a flashing LED. there is no movement at the motor. what am I doing wrong here.
what checks do I need to do to make this work. thanks, michael