Hello. Thanks for looking at my problem.
linux 2.4.5
I'm using a smithy sherline cnc. Bobcad v31 4 axis.
I have the correct bobcad post processor (I think) but when I try to load the gcode file onto my machine I get the error.
line 21...file name/ bad character "a" used.
The file will not even load onto the machine.
I think that A axis is :
not defined in linux on machine.
or
controller can't read 4 decimal digits for a rotary axis
I have looked at the hal configuration and A axis there under parameters.
Do you have to enable A axis in linux ? If so where?
Thanks
jc